The tolerate command instructs the shell not to abort processing
of the script if the next command generates one or more
warnings, errors, or severe errors. For the purposes of this
command, a blank line counts as a command, so be sure to
place the tolerate command immediately above the command
about which you wish to be tolerant.
Syntax : tolerate = "tolerate"
The tolerate command was introduced to allow FunnelWeb (i.e.
the fw command) to be tested in a script under conditions which
would normally cause it to abort the script.
Copyright Ross N. Williams 1992,1999. All rights
http://www.ross.net/funnelweb/reference/commands_tolerate.html [3/3/2000 10:45:31 PM]