G e t t i n g   s t a r t e d

Tip: If you have inserted the battery, but the device does not start up, press

the power key.

Charging the battery

1. Connect the charger to an AC wall outlet.

2. Connect the power cord to the bottom of the device. 

See Fig Keys and connectors, p.10.

 The battery indicator bar starts

scrolling on both displays. If the battery is totally discharged, it may take a few minutes before the charging indicator is

shown. The device can be used while charging.

3. When the battery is fully charged, the bar stops scrolling. Disconnect the charger from the device and then from the AC outlet.

When the battery charge level is too low for operation, the device switches itself off. If the cover phone switches off, the

communicator interface may still be active for a while.

Switching the device on and off

1. To switch the device on, press and hold the power key.

2. If the device asks for a PIN or security code, enter the code, and press 

OK

.

3. To switch the device off, press and hold the power key.

Tip: When you switch the phone on, it may recognize the SIM card provider and configure the correct text message,

multimedia message, and GPRS settings automatically. If not, contact your service provider for the correct settings.

The communicator interface starts up first after the battery is inserted. You cannot switch on the cover phone immediately after

the battery has been inserted, you must wait until the communicator interface has started.

Tip: If you have inserted the battery, but the device does not start up, press the power key.

The communicator interface can be used without the phone functions when a SIM card is not inserted or when the 

Offline

 profile

is selected.

Antenna

Your device has an internal antenna.

Note:  As with any other radio transmitting device, do not touch the antenna unnecessarily when the

device is switched on. Contact with the antenna affects call quality and may cause the device to operate

at a higher power level than otherwise needed. Avoiding contact with the antenna area when operating

the device optimises the antenna performance and the battery life.

The picture shows the normal use of the device at the ear for voice calls. 

See "Operating environment," p.104.

Access codes

The device uses several access codes to protect against unauthorized use of the device and the SIM card.

You need the following access codes:

Copyright   2005 Nokia. All Rights Reserved.

9